Append Command

You can use these to add a new command to the end of a shape's command list. These new commands will start out with their parameters randomized, but you can change them to whatever you want.

Each shape in a design maintains a variable-length list of operations in an internal language. This list can be modified in mutation to lengthen, shorten, and recombine with others. These commands are run on each shape as it goes from genotype to phenotype.

These are the commands in our language:

  Cuts a piece out of a shape. Takes two parameters both from 0-1: Start of cut and length of cut. (Opening is notoriously flaky. If you see odd results do not be too surprised.)
  Moves a shape in the X, Y, and Z directions. Takes three parameters.
  Scales a shape in the X, Y, and Z directions independently. Takes three parameters.
  Rotate a shape in the XY plane by a certain number of degrees. Takes one parameter.
Note: AgencyGP's Z dimension is up/down. It corresponds to Maya's Y dimension.